Vertical heat storage from 2 m³ to 200 m³

Heating buffer storage tanks are designed for operation without air cushions in closed heating systems - with an operating pressure of 3 bar, 6 bar or 10 bar as standard - we are happy to offer different operating pressures. Wind loads up to wind zone 2 are taken into account in the standard. If necessary, higher wind loads and earthquake loads are calculated and taken into account in the container construction.

Decades of experience in tank construction, state-of-the-art production facilities and our modular system enable shorter delivery times and a good price-performance ratio. We recommend the insulation applied at the factory. This guarantees short assembly times on site.

Optimal use of the generated energy is usually only possible if sufficient storage capacity is available. The efficient and inexpensive storage medium is usually water - be it in the form of heat or cold. Thanks to our experience of over 50 years in tank construction made of steel, we can now offer you cost-effective solutions for heat and cold storage, above and below ground and storage in special constructions.

We support you in the selection of the optimal storage tank and design feed and extraction pipes with you. Experience in the design of buffer storage tanks and nozzle systems results in a very low laminar flow, even with high extraction rates, and thus a largely stable stratification.

Heating buffer storage tanks are designed for operation without air cushions in closed heating systems with an operating pressure of 6 bar and wind loads up to wind zone 2. If necessary, higher wind loads and earthquake loads are also calculated and taken into account in the container design.

We recommend the factory-installed insulation and vacuum breaker. This guarantees short assembly times on the construction site.